-
Item# LEN-3GS01
The LEN L3GS01 3G-SDI Splitter is suitable for additional monitor feeds; remote camera locations and situations where size and weight are critical factors - such as racing cars, bikes and other sporting and research applications.
Note: To achieve the specified performance the input must be fed with a source impedance of 75 ohms and both outputs must be terminated with 75 ohms. Therefore, if an output cable is not present, a 75 ohm termination should be fitted. Please check that...
-
Item# LEN-HDS01
The LEN LHDS01 HD Splitter is suitable for additional monitor feeds; remote camera locations and situations where size and weight are critical factors - such as racing cars, bikes and other sporting and research applications.Create two Broadcast quality signals from one input covering all formats up to and including HD. All connections are on the same face - ideal for permanent installations.
Drive capability can be up to 70 meters depending on cable quality and strength of original signal.
...
-
Item# LEN-3GR01
The LEN L3GR01 serial digital video relay provides full broadcast quality switching, for all data rates up to 3 GBits/sec. It is ideal for applications such as power failure switching, where a local SDI source is automatically switched in on failure of an incoming SDI signal from a remote source
Features: Two way 3G-SDI digital video signal relay
Transparent to all 3G, HD and SD formats with data rates up to 3GBit/s
Size 45 x 30 x 15 millimetres
Optional rack frame to hold eight relays...
-
Item# LEN-L4KGI01
The LEN L4KGI0 ground isolators use broadband high-pass filters to provide complete galvanic isolation of DC currents between two pieces of equipment, while permitting the full bandwidth of SDI signal to pass, thus avoiding problems of signal distortion and operator shocks caused by a voltage difference. This method out-performs broadband transformers for SDI signals. Both the signal and ground paths between equipment are isolated, there is no distortion of the signal. They are suitable for...
-
Item# LEN-L4KGI02
The L E N ground isolators use broadband high-pass filters to provide complete galvanic isolation of DC currents between two pieces of equipment, whilst permitting the full bandwidth of the SDI signal to pass, thus avoiding problems of signal distortion and operator shocks caused by a voltage difference. This method out-performs broadband transformers for SDI signals. Both the signal and ground paths between equipment are isolated, there is no distortion of the signal. They are suitable for ASI...
-
Item# LEN-LHDF03
The LEN LHDF03 is suitable for SD or HD SDI signals. These have a higher breakdown voltage as required for medical applications. They are built into Insulating ABS boxes with mounting flanges, fitted with two female BNC connectors.
Traditional "Humbucker" and Isolation Transformer approaches to interference are not applicable to SDI signals. Mains hum is well below the SDI signal frequency spectrum and (unlike analogue video) the SDI signal is not sensitive to near-DC attenuation. However,...
-
Item# LEN-HDR01
The LEN LHDR01 serial digital video relay full broadcast quality switching, for all data rates up to 1485 MBitHD-SDI.
It is ideal for applications such as power failure switching, where a local HD-SDI source is automatically switched in on failure of an incoming HD-SDI signal from a remote source.
Features: Two way HD-SDI digital video signal relay
Transparent to all HD-SDI and SD formats with data rates up to 1485 MBit
Size 45 x 30 x 15 millimeters
Optional rack frame to hold eight...
-
Item# LEN-LAMS01
The LEN LAMS01 AES / MADI / ASI Splitter is a miniature, lightweight passive design, requiring no power, L E N digital signal splitters are a direct equivalent to the use of a Distribution Amplifier to create additional AES, MADI or ASI signals, for most applications.
LEN AES / MADI / ASI Splitters are also ideal for such applications as additional feeds say in remote locations, and in situations where size and weight are critical factors. Offering a broadcast-quality signal, they are useful...
-
Item# LEN-L3GGI01
The LEN L3GGI 01 is a galvanic signal and gound path isolator for use with 3G HD, SD & SDI video signals. They are built in cylindrical "barrel" style enclosures and fitted with a BNC connector at each end and isolate both the signal and ground paths.
Specifications: Bandwith: 0.5MHz to 3.0GHz
DC Breakdown Voltage: 100 volts minimum
Input and Output Impedance: 75 ohms
Return Loss: >20dB
Dimensions:...
-
Item# LEN-VIT01
The L E N Video Isolation Transformer acts as BOTH a Hum Eliminator AND a Ground Isolator whilst also improving on the performance of the traditional individual products.
The VIT01 will remove severe interference caused by 50 or 60 Hz hum whilst a normal "Humbucker" will only remove moderate interference.
At the same time it acts as a Ground Isolator eliminating ground potential differences between equipment with a minimal phase and gain distortion.
NOTE: See model VHE-100 Video Hum Eliminator...
-
Item# LEN-VIT02
The LEN VIT02 Video Isolation Transformer acts as BOTH a Hum Eliminator AND a Ground Isolator whilst also improving on the performance of the traditional individual products.
The VIT02 will remove severe interference caused by 50 or 60 Hz hum whilst a normal "Humbucker" will only remove moderate interference.
At the same time it acts as a high performance Ground Isolator eliminating ground potential differences between equipment with a minimal phase and gain distortion. The VIT02 has...
-
Item# LEN-LHDF03-BSTK
The LEN LHDF03 is suitable for SD or HD SDI signals. These have a higher breakdown voltage as required for medical applications. They are built into Insulating ABS boxes with mounting flanges, fitted with two female BNC connectors.
Traditional "Humbucker" and Isolation Transformer approaches to interference are not applicable to SDI signals. Mains hum is well below the SDI signal frequency spectrum and (unlike analogue video) the SDI signal is not sensitive to near-DC attenuation. However, the...
-
Item# 3GF01
Traditional "Humbucker" and Isolation Transformer approaches to interference are not applicable to SDI signals. Mains hum is well below the SDI signal frequency spectrum and (unlike analogue video) the SDI signal is not sensitive to near-DC attenuation. However, the problems of signal distortion and operator shocks caused by a voltage difference between two pieces of equipment connected by a HD-SDI signal feed still exist.
The LEN L3GF01 3G-SDI Ground Isolator uses a broadband highpass filter...
-
Item# LEN-HDF01
Traditional "Humbucker" and Isolation Transformer approaches to interference are not applicable to SDI signals. Mains hum is well below the SDI signal frequency spectrum and (unlike analogue video) the SDI signal is not sensitive to near-DC attenuation. However, the problems of signal distortion and operator shocks caused by a voltage difference between two pieces of equipment connected by a HD-SDI signal feed still exist.
The LEN LHDF01 HD Ground Isolator uses a broadband highpass filter to...
-
Item# LEN-L3GF03
The L3GF03 may used with SD, HD or 3G SDI. These have a higher breakdown voltage as required for medical applications. They are built in are constructed in ABS boxes with mounting flanges, fitted with two female BNC connectors.
Specifications: Dimensions: 50 x 35 x 15 (L x W x H) mm excluding mounting flanges, 68mm length including flanges.
-
Item# LEN-L3GVHE01
The L3GVHE01 is a Video Hum Eliminator for use with 3G, HD, SD SDI and ASI video. Impedance: 75 ohms Features: Specifications: Equivalent cable length, working with SD SDI or ASI: 15m Belden 8281
Equivalent cable length, working with 3G/HD SDI: 20m Belden 1694
Amplitude ripple: Better than 0.5 dB, DC to 3000MHz,
Group delay ripple: Less than 3nS, DC to 3000MHz
Dimensions: 120 x 90 x 60 (h x w x d)mm, excluding mounting flanges.
Weight: 800gm.
-
Item# LEN-LAMF01
The L E N AES / MADI / ASI ground isolator uses a broadband high-pass filter to provide complete galvanic isolation of DC currents between two pieces of equipment, whilst permitting the full bandwidth of the digital signal to pass, thus avoiding problems of signal distortion and operator shocks caused by a voltage difference. This method out-performs broadband transformers for these digital signals. Additionally, some broadband transformers invert the signal, which is incompatible for use with ASI....
-
Item# LEN-L4KS01
Miniature, lightweight passive designs, requiring no power, L E N SDI splitters are a direct equivalent to the use of a Distribution Amplifier to create additional SDI signals, for most applications.
L E N Splitters are also ideal for such applications as additional monitor feeds say in remote camera locations, and in situations where size and weight are critical factors, such as racing cars, bikes and other sporting and research applications. Offering a broadcast-quality signal, they are useful...
-
Item# LEN-LMPHDS8
The LEN LMPHDS8 is a 1RU rackmount panel that houses 8 Single Channel LEN-HDS01 HD-SDI splitters. HD Splitter is suitable for additional monitor feeds; remote camera locations and situations where size and weight are critical factors - such as racing cars, bikes and other sporting and research applications.Create two Broadcast quality signals from one input covering all formats up to and including HD. All connections are on the same face - ideal for permanent installations.
Drive...
-
Item# LEN-LAMR01
The LAMR01 AES / MADI / ASI Relay is a miniature single-circuit, change-over relay, providing full broadcast quality switching, for data rates up to 360 Mb/s. It is suitable for applications such as power-failure switching and source selection. It can be used to choose between two inputs or to have a single input and choose between two outputs, controlled by a 5V DC applied to the coil.
It is built in an ABS enclosure fitted with three female BNC connectors, with mounting screws,...
-
Item# LEN-L4KR01
The L E N Video Relays are miniature single-circuit, change-over relays providing full broadcast quality switching, for data rates up to 12Gb/s. They are suitable for applications such as power-failure switching and source selection. They can be used to choose between two inputs or to have a single input and choose between two outputs, controlled by a 5V DC applied to the coil.
Three models are available: The L4KR01 is for use with full 12G/4K UHD SDI video and all lower standards...